ultraviolet laser resistor trimming system

Brand Name:YAGEO

Model Number:RC1206JR-07100RL

Place of Origin:Original

... composition of the resistive element is a noble metal imbedded into a glass and covered by a second glass to prevent environment influences. The resistor is laser trimmed to the rated resistance value. The resistor is covered with a protective epoxy coat,

Brand Name:YAGEO

Model Number:RC0805FR-072K49L

Place of Origin:Original

... composition of the resistive element is a noble metal imbedded into a glass and covered by a second glass to prevent environment influences. The resistor is laser trimmed to the rated resistance value. The resistor is covered with a protective epoxy coat,

Brand Name:Rohm Semiconductor

Model Number:ESR10EZPJ391

Place of Origin:China

...laser trimming technology results in significantly improved surge resistance characteristics. 2) 2kV to 5kV electrostatic discharge resistance. 3) Superior power ratings. 4) ROHM resistors have obtained ISO9001 / IATF16949 certification. 5) Corresponds to AEC-Q200. andnbsp; Type Description Select All Category Resistors Chip Resistor...

Brand Name:HX

Model Number:HX-6005

Place of Origin:Guangdong, China (Mainland)

Tear By Hand Colorful Craft Art Paper Trim Masking Tape For Decoration Spray Product Description The Masking Tape uses crepe paper as the backing material, which is coated with rubber type adhesive. Applicable to different temperature resistance with ...

Brand Name:Vishay

Model Number:RCA06032K00JNEA

Place of Origin:USA

.... A cermet film layer and a glass-over are deposited on a high grade (Al2O3) ceramic substrate with its prepared inner contacts on both sides. A special laser is used to achieve the target value by smoothly fine trimming the resistive layer without

Brand Name:ADI

Model Number:AD592ANZ

Place of Origin:Original Factory

... temperature. For a wide range of supply voltages the transducer acts as a high impedance temperature dependent current source of 1 µA/K. Improved design and laser wafer trimming of the IC’s thin film resistors allows the AD592 to

Brand Name:ADI

Model Number:AD590JH

Place of Origin:USA

... temperature. For supply voltages between 4 V and 30 V the device acts as a high-impedance, constant current regulator passing 1 μA/K. Laser trimming of the chip’s thin-film resistors is used to calibrate the device to 298.2 μA output at 298.2 K

Brand Name:CSPPM

Model Number:PPM-T132C

Place of Origin:China

... pressure acts on the silicon sensitive components through the pressure interface to achieve a linear conversion between the applied pressure and the output voltage signal. The laser trimmed thick film resistor

Brand Name:Original Factory

Model Number:AD1866RZ-REEL

Place of Origin:CN

... while requiring a single +5 V power supply. The monolithic chip includes CMOS logic elements, bipolar and MOS linear elements and laser trimmed, thinfilm resistor elements. Careful design and layout techniques have resulted in low distortion, low noise,