Home > Electrical Equipment & Supplies > Electrical Instruments > Battery Testers >

Iec 62196 1 Test Apparatus

1-10 Results for

iec 62196 1 test apparatus

from 43 Products

IEC 62196-1 Test Apparatus For Checking Damage To VE Conductors with 10Rpm

IEC 62196-1 Test Apparatus For Checking Damage To VE Conductors with 10Rpm 1. Introduction of apparatus for checking damage to VE conductors: The apparatus for checking damage to EV conductors is designed to meet the test requirements of IEC62196-1 clause 13.3 figure 12, IEC60884-1:2022 clause 12.2.5 and figure 13, IEC60669-1 clause 12.2.5 and figure 9, IEC62052-31 clause 6.9.7.3 (for flexion test). The apparatus......

Pego Electronics (Yi Chun) Company Limited

Address: No. 317, Yichun South Road ( Happiness Park), Yuanzhou District, Yichun, Jiangxi, 336000, China

IEC 62196 Jointed Test Finger EV Connector Testing Equipment

IEC 62196 Jointed Test Probe For Electric Vehicle Connector Test Complied Standards & Clauses IEC 62196-1Ed.4CDV 2020 clause 10.1. Equipment Overview This is a precision test finger made in accordance with many standards like IEC 62196-1Ed.4CDV 2020 clause 10.1. This probe is intended to verify the basic protection against access to hazardous parts. It is also used to verify the protection against access with a finger. This test......

Sinuo Testing Equipment Co. , Limited

Address: Room 101, 1st Floor, No. 6, Third Street, Pingshan Industrial Zone, Shibi Street, Panyu District, Guangzhou, China

IEC 62196 Vehicle Testing Equipment 5000N Drive Over Test For Plug / EV Connector

IEC 62196 Vehicle Testing Equipment 5000N Drive Over Test For Plug / EV Connector Product information: The test equipment is used to check whether a plug or vehicle connector shall have adequate resistance to damage from being driven over by a vehicle, unless it is provided with a cable management system which prevents the accessory from being left on the ground. It is required by IEC 62196-1:2022 clause 33, IEC 62752:2016 clause 9.34, etc. Test...

Sinuo Testing Equipment Co. , Limited

Address: Room 101, 1st Floor, No. 6, Third Street, Pingshan Industrial Zone 511495, Shibi Street, Panyu District, Guangzhou, China

IEC 62196-1 Test Plug Gauge Of Vehicle Connector Withdrawal Force Test Die Steel

Product Description IEC 62196-1 Test Plug Gauge Of Vehicle Connector Withdrawal Force Test Die Steel Product Overview: The Test Plugs Are Required By IEC 62196-: 2022 Clause 14.1.5, 14.1.6, According To The Relevant Standard Sheets, Shall Have Finely ......

KingPo Technology Development Limited

Address: RM C, 13/F, HARVARD COMMERCIAL BUILDING, 105-111 THOMSON ROAD, WAN CHAI, HK

IEC 60335 Tracking Test Apparatus CTI Comparative Tracking Index Tester Apparatus

IEC 60335 Tracking Test Apparatus CTI Comparative Tracking Index Tester 1. Reference standard IEC60335, GB4706.1, IEC 6084-1, GB2099.1, GB/t4207-2003, IEC 60112. 2. Technical specifications This product is used for electrical products affected by damp and ......

DONGGUAN LONROY EQUIPMENT CO LTD

Address: A31, 11 Floor, No 1 Building, Minjian Jinrong Building, No 111 Guantai Road, Sanyuanli Community, Nancheng Street, Dongguan, Guangdong, China

IEC 60068-2-75 Impact Testing Machine Spring Hammer Test Apparatus 0.2J Energy

... apparatus. And other standard such as IEC 60335-1, IEC60884-1, IEC 60598-1, IEC60065-1, IEC 62368-1 and etc. When is an impact test appropriate? An impact test is appropriate for equipment likely to be used in areas with non-restricted access and where...

HJ AUTOMATIC CONTROL TECHNOLOGY CO., LTD

Address: No.6-36, Yaogu Farm, Shibi No.3 Village, Shibi Street, Panyu District, Guangzhou, Guangdong, China

Household Appliance 7 Inch Fire Hazard Needle-Flame Test Apparatus IEC 60695-11-5

... wire test equipment, hot wire ignition test machine and etc.. The new version PLC control 7 inch needle-flame tester is designed and manufactured according to the standard requirement of IEC60695-......

Guangzhou HongCe Equipment Co., Ltd.

Address: No.6-39, Yaogu Farm, Shibi No.3 Village, Shibi Street, Panyu District, Guangzhou

IEC 60811-504 2012 Mandrel Test Apparatus & Impact Test Apparatus

... or round insulated cores at low temperature. The manual low-temperature impact test device is used to measure the samples of wire and cable insulation and jacket, plugs and sockets, insulating electrical sleeves and accessories for construction. After...

DONGGUAN DAXIAN INSTRUMENT EQUIPMENT CO.,LTD

Address: No.168 Zhen'an West Road Changlian Industry Mansion Xiabian Community Dongguan China

AC220V 50HZ Power Cord Flexing Test Apparatus With Digital Display

...Adjustable Bend Angle Product information: This test apparatus checks the protection of the supply cord where it enters the appliance. It conforms to the standard requirement of IEC60335-1 clause 25.14. Appliances provided with a ......

Dongguan Kingpo Technology Limited

Address: RM C, 13/F, HARVARD COMMERCIAL BUILDING, 105-111 THOMSON ROAD, WAN CHAI, HK

IEC60598-1 Luminaries Test Equipment Direct Plug In Test Apparatus

... of the plug-in device with plug-in pin on the socket during normal use is within the specified range. Compliance: It is suitable for testing the torque exerted on the output socket by the device which is to be inserted into the fixed output socket and is...

SKYLINE INSTRUMENTS CO.,LTD

Address: No.1802 Room 6# Building Universal Commerce Center Nancheng District Dongguan Guangdong China

Submit your “iec 62196 1 test apparatus” inquiry in a minute :

*From:	Your email address is incorrect!
To:	SKYLINE INSTRUMENTS CO.,LTD Products: IEC60598-1 Luminaries Test Equipment Direct Plug In Test Apparatus
*Subject:	Your subject must be between 10-255 characters!
*Message:	For the best results, we recommend including the following details: --Self introduction --Required specifications --Inquire about price/MOQ Your message must be between 20-3,000 characters!
	Please reply me within 24 hours. Yes! I would like your verified suppliers matching service! Yes! If this supplier doesn't contact me in 3 days, I want everychina.com to recommend me more suppliers.

Submit “iec 62196 1 test apparatus” inquiry

*From:
Your email address is incorrect!
To: Pego Electronics (Yi Chun) Company Limited
*Subject:
Your subject must be between 10-255 characters!
*Message:
For the best results, we recommend including the following details: --Self introduction --Required specifications --Inquire about price/MOQ Your message must be between 20-3,000
Yes! I would like your verified suppliers matching service!

Inquiry Cart 0