IEC 62196-1 2022 Drop Test Equipment For Rewireable EV Plugs And Vehicle Connectors
|
... 26.3, figure 19. It is used to test the mechanical strength of rewirable plugs and vehicle connector which is equipped with flexible cable. Test principle: The free end of the cable and an additional rope or other flexible means, etc., attached to the...
Sinuo Testing Equipment Co. , Limited
|
IEC 62196-1 Electric Vehicle Testing Equipment Air Saturated Test Chamber
|
IEC 62196-1 Electric Vehicle Testing Equipment Air Saturated Test Chamber Complied Standards & Clauses This air-saturated test chamber is required by IEC 62196-1:2022 clause 30. Equipment Overview It is used to process further rusting in saturated water ......
Sinuo Testing Equipment Co. , Limited
|
EV Charging Connector Tester with Compliance to GB/T 18487.1-2023 GB/T 20234.1-2023 and IEC 62196-1:2022 Standards
|
...equipment complies with the test requirements of Clause 10.3 of Standard GB/T18487.1-2023, Clause 7.22 and Clause 7.23 of Standard GB/T 20234.1-2023, Chapters 22 and 23 of IEC 62196-1: 2022, and Chapter 8.2.3 of IEC EN 62752-2018. It is suitable for the life test and normal operation test of the disconnection capability of various types of electric vehicle charging connectors. (2) Equipment......
KingPo Technology Development Limited
|
IEC 62196-1 PLC Electric Vehicle IP5X And IP6X Sand Dust Testing Equipment
|
IEC 62196-1 PLC Electric Vehicle IP5X and IP6X Sand Dust Testing Equipment 1. Introduction: The sand dust testing equipment is applied to test the physical and other related properties of electronic and electrical products, electric vehicle, lamps, ......
Pego Electronics (Yi Chun) Company Limited
|
IEC 62196-1 Connection Set Conductive Charging For Electric Vehicles Test Machine
|
IEC 62196-1 Connection Set Of Conductive Charging For Electric Vehicles Test Machine Introduction: IEC 61851-1 specifies electric vehicle conductive charging equipment. This international standard, referred to as the IEC 60309 series in IEC 61851-1, specifies the requirements for plugs, socket-outlets, connectors, inlets and cable assemblies as described in IEC 61851-1. Some charging can be achieved by direct connection from an electric vehicle...
Guangzhou HongCe Equipment Co., Ltd.
|
