hot surface igniter

Brand Name:KRHX

Model Number:KR-ST

Place of Origin:China

... only need approx. 1/10 of the energy of that needed by hot air fans and ignition blowers. Their ignition capacity lies between 120 and 200 watt. Depending on the positioning of the ignition element in the boiler, the ignition time of approx. 60 seconds is

Brand Name:Kingpo

Model Number:KP-FT3540

Place of Origin:China

...hot surface ignition temperature tester determines the lowest temperature at which A2L refrigerant can be ignited by a high-temperature hot surface under specific conditions; this is known as the hot surface auto-ignition temperature. This data is crucial for assessing the potential fire risk when refrigerant leaks and encounters hot surfaces...

Brand Name:YUYANG

Model Number:YYF050

Place of Origin:China

...Hot Wire Ignition Test Apparatus Hot wire ignition tester Application: It is suitable for electric and electronic products, household appliance materials to do ignition dangerous test. It simulates the heat source or ignition source of simulates glow component and overload resistance which may cause thermal stress in a short time.Hot-wire coil ignition...

Brand Name:HongCe

Model Number:HWI-1

Place of Origin:China

...requirements of the "Glow Wire Ignition Test Method" in relevant standards. It is suitable for the ignition risk test of electrical and electronic products and household appliances, and simulates heat sources such as hot components or overload resistors.

Brand Name:HJ

Model Number:HWI-1

Place of Origin:China

...Hot wire ignition tester With Electrical control Standard: IEC60950-1 Information technology equipment – Safety – Part 1: General requirements Annex A.4 Hot wire ignition test; IEC60947-1 Low-voltage switchgear and controlgear –Part 1: General rules Annex M M.1 Hot wire ignition test (HWI); IEC60695-2-20 Fire hazard testing — Part 2: Glowing/Hot wire based test methods — Section 20: Hot...

Brand Name:PEGO GROUP

Model Number:HW-1

Place of Origin:China

...Hot Wire Ignition Test Apparatus /Fire Hazard Testing Equipment 1. Introduction The hot wire ignition test apparatus is designed according to the standards of IEC60950, IEC60695-2-20, UL60950, ASTMD3874 and etc.. The hot wire ignition test uses a heating wire of a specific size (Φ0.5 mm* 250 mm) and a specific material (Ni80/Cr20), after pre-annealing with specified heating power (0.26W/mm) and the specified time (8s~12s), the hot

Brand Name:KINGPO

Place of Origin:Mainland China

... of the "Glow Wire Ignition Test Method" in relevant standards. It is suitable for the ignition risk test of electrical and electronic products and household appliances, and simulates heat sources such as hot components or overload resistors. The

Brand Name:SHC

Model Number:SC-HWI

Place of Origin:China

... resistance 5.28Ω/m Anneal holder distance 250mm Specimen holder distance and height 70mm,height:60mm (the distance between the holder surface to the tray surface) Wire wrapping tension and its distance 5.4N±0.05N, 6.35mm±0.

Brand Name:Sinuo

Model Number:SN778

Place of Origin:China

IEC 60695-2-20 Hot Wire Ignition Coil Test Method Apparatus Complied Standards & Clauses IEC60695-2-20 “Fire hazard testing - Part 2: Glowing/Hot wire based test methods - Section 20: Hot-wire coil ignitability test on materials” Equipment Overview ...

Brand Name:Haida

Model Number:6004-HD

Place of Origin:China

Hot-Wire Ignition Tester Product Description This tester simulates fire hazards as specified in IEC 60695-2-20, UL 60950, IEC 60950-1999, and ASTM D3874-1997. It employs a heating wire of specific dimensions (0.5mm × 250mm) and material (Ni80/Cr20), pre-annealed at a defined power (0.26W/mm) and duration (8-12 seconds). The wire is wound in five full turns around the sample at a 6mm pitch, then tested at the same power (0.26W/mm) until ignition

Place of Origin:China

Brand Name:KeRang

... test. It simulates the heat source or ignition source of simulates glow component and overload resistance which may cause thermal stress in a short time. Test sample:Information technology ...

Brand Name:VOUCH

Model Number:5114

Place of Origin:CHINA

Standard GB5169 Glow Wire Test Apparatus , Hot Wire Ignition Test Flammability Temperature Test GLOW WIRE TEST APPARATUS OF MODEL 5114 Glow Wire Tester could be applicable to ignition hazard test, combustibility test of electronic industry, home electronic...

Brand Name:CHENG JU

Place of Origin:Guangdong，China

Carbon ERW Hot Surface Techniq Welded Seamless Tube Iron Round Welded Steel Pipes Product Detail: Type Welded Steel Pipe Materials ...

Brand Name:TONGMAO

Model Number:Stainless steel coil

Place of Origin:China

... Galvanized Galvalume Prepainted Hot Surface Technique Product Description: item value Standard ASTM Grade SGCC Place of Origin China Brand Name Tong Mao Model Number EN10215 Type Steel Plate Technique Cold Rolled Surface Treatment galvanized Application ...

Brand Name:Vanka

Place of Origin:China

Gas Stove Spare Parts Gas Oven Hot Surface Ignitor *, *::before, *::after {box-sizing: border-box;}* {margin: 0;}html, body {height: 100%;}body {line-height: 1.5;-webkit-font-smoothing: antialiased;}img, picture, video, canvas, svg {display: block;max-...

Brand Name:SYL

Model Number:04,304L,316,316L,309S,310S,321

Place of Origin:CHINA

... 1.44621.4410 1.4833 1.4845 Outter Diameter (OD) 3-1220mm Thickness 0.4-120mm Length 6000mm 5800mm 12000mm or Customized Surface Finished No.1 No.3 No.4 HL 2B BA 4K 8K 1D 2D End/Edge Plain Mill Technique Cold Drawn or Hot Standard ASTM AISI DIN JIS GB EN

Place of Origin:Chongqing

Model Number:DZQ6B

DZQ6B Engineering Seismograph (Surface Wave Instrument) ADD: NO.1 Kuaileli, Xiaolongkan Street, Shapingba District, Chongqing China; Skype: lucyfang9 ; Website: www.lucydrillingrig.com, email: lucyfang15@yahoo.com; M: +86-13628481197 TEL.:+86-15923510719,...

Place of Origin:China (Mainland)

Brand Name:OEM

Model Number:HQ1024

hot sale motorcycle main switch,motorcycle Ignition Switch for HQ1024 Product Description 1.High quality with reasonable price, 2.OEM/ODM, 3.Excellent packing. 4.Motorcycle ignition switch as blow, motorcycle ignition switch Details: Type: ignition switch Working life: more than 50000 cycles Material: plastic or aluminum Surface...

Brand Name:AI

Model Number:AIC-695220

Place of Origin:China

... The hot wire ignition test chamber is designed according to IEC 60695-2-20 and GB 4943 standards and conforms to the standard hot wire ignition test method. This hot wire ignition test chamber is mainly used for testing the hot wire ignition hazard...

Place of Origin:China

Brand Name:WIMMA

Model Number:CG125

Hot Selling Chinese Motor Spare Parts CG125 Ignition Coil With Competitive Price The low-voltage electricity output when the CDI energy storage capacitor is discharged is input into the primary side coil of the ignition coil. After electromagnetic induction by the ignition coil, the high-voltage electrical equipment required for the ignition...