Easy install 230V Non-programmable LCD Display Smart Home Thermostat

Easy install 230V Non-programmable LCD Display Smart Home Thermostat

ISO certifications .pdf

Features:

Digital thermostat
Wall mounted
Heat/OFF/Cool switch
Room Temperature Calibration adjustment
Power supply: 230 VAC,6(2)A,50/60 Hz for hardwire (common wire)
2*AAA 1.5V Alkaline batteries power

Model No.:ST2601

Relay Wiring

1(NC),2(COM),3(NO)

Heating: connect the two connection wires of the device to be controlled to terminals No. 3 (NO) and No. 2 (COM), i.e. to the normally open terminals of the relay

Cooling: the two connection wires of the cooling equipment should be connected to terminals No. 2 (COM) and No. 1 (NC), i.e. to the normally closed terminals of the relay.

• To prevent electric shock, replace the inner cover removed for the connection of wires after the assembling process has been completed.

The device must be installed and connected by a qualified professional. Always follow the manufacturer's instructions when connecting the thermostat to any heating or cooling appliance.

The voltage appearing at terminal No. 1, No. 2 or No. 3 depends only on the system being controlled, therefore the dimensions of the wire are determined by the type of the device to be controlled. The length of the wire is of no significance.

Running Mode

Hold the dial button for 5 seconds to access the system running mode switch, then turn the dial to choose different mode between:

-- HEAT (Heating): adjust the temperature by turn the dial

-- COOL (Cooling): adjust the temperature by turn the dial

-- OFF (Frost Protection): it will start heating when the room temperature is under 7°C

Then press the dial again to confirm the running mode or wait for 10 seconds to confirm the setting automatically.

Calibrate the temperature

Temperature calibration and SWING settings): Hold the dial for 5 seconds to access to the mode switch setting and select HEAT or COOL mode, then press the dial to access the interface of temperature calibration “CAL” (in -3.0~+3.0, in 0.5°C increments); turn the dial to set the desired value, then press the dial again to set the Swing value between 0.2~2°C.

Restoring thermostat to factory default

Remove the batteries then put it back, hold the dial until display the full screen then release, the defaul running mode is HEAT, it means the thermostat has been restored to factory default settings.

Ocean Controls Limited was founded by an industrial engineer with 15 years experience in the design and manufacturer of top-end electronic room thermostats.

We provide OEM/ODM services to worldwide customers, including manufacturing, designing,engineering and tooling.

With many years of experience, our products feature unrivalled quality, reliability and durability. We export our products all over the world, especially to European and American markets. Currently our main products includ: non-programmable/programmable thermostats,dial/push button/touchscreen thermostats, wired and wireless thermostats,we can also make timer,immersion/capillary thermostat and other related heating system control parts as per the customer’s request. The products meet CE, R&TTE,FCC,UL and CSA approved quality standards.

Our factory has three sets of SMT,10 sets of injection molding machine and advanced moulding equipments, Monthly capacity is more than 50,000 pcs, and this can be expanded according to customer requirement.

We have a strong R&D team with more than 15 years experience in the thermostat field, They are seasoned in the design,develop and testing of electronic thermostats, HVAC controller and accessories. In addition, we have broad experience in RF remote control products like remote wireless thermostats. Based on the above, we can design/develop new models for you upon your technical specifications or samples.

As a company, we strive to excel in the quality of products we sell, the service we provide and the support we give. We are committed to continuous improvement and on building win-win relationships with our partners.