Product description for 310ml Eco-friendly Moisture-curing PU urethane adhesive Sealant

PL870 is a one component moisture curable polyurethane glass adhesive.

it is good sealing performance and cohesion.

It has no corrosion, pollution and environmental pollution to the bonded substrate, and has good adhesion to metal, glass and other substrates.

Product application for 310ml Eco-friendly Moisture-curing PU urethane adhesive Sealant

1.Bonding and sealing Maintenance of automobile windshield and side window glass
2.Used for the high strength adhesion of the glass and the body of various vehicles.

3.Low speed electric vehicle glass installation and sealant.
4.Good Adhesion with various substrates such as glass, aluminum plate etc

Product application for 310ml Eco-friendly Moisture-curing PU urethane adhesive Sealant

1.Eco-friendly, no volatilization after curing, no harm to human body.

2. Good adhesion and sealing, high bonding strength.Primerless.
3. Good thixotropic and extrusion properties, convenient construction.
4.Can withstand high strength dynamic loads; no sagging while interrupting gluing
5. Single component, moisture curing, no dripping for vertical application
6.Good aging resistance and weather resistance

Technical data table for 310ml Eco-friendly Moisture-curing PU urethane adhesive Sealant

Attention:

Fast and keep away from children; Avoid contact with eyes and skin before curing. In case of accidental contact with skin, first scrub with soapy water or alcohol, and then rinse with clean water. In case of contact with eyes, rinse with plenty of water first, and seek medical advice immediately if necessary.

Directions for Use for 310ml Eco-friendly Moisture-curing PU urethane adhesive Sealant

Tool: Pneumatic plunger caulking gun

Cleaning: Clean and dry all surfaces by removing foreign matter and contaminants such as oil dust, grease, frost, water, dirt, old sealants and any protective coating.

Steps:

1. Cut nozzle to give the required angle and bead size

2. Pierce the membrane at the top of the cartridge and screw on the nozzle

3. Place the cartridge in an applicator gun and squeeze the trigger with equal strength

Packing:

Substrate pretreatment for for 310ml Eco-friendly Moisture-curing PU urethane adhesive Sealant

The surface of the bonded substrate must be clean and dry without dust, oil and water stains. The bonded
substrate should be cleaned and pretreated with detergent or primer. If it is not, it may cause bonding failure. The glue shall be applied and cured according to the construction method, and the safe driving time is related to the ambient temperature and humidity.

Construction
Ambient temperature and humidity have a great impact on the surface drying and curing of glass adhesive. It
is recommended that the construction ambient temperature be 5 ~ 35 ℃, and the humidity be 50 ~ 70% RH. When the temperature is lower than 5 ℃, it is recommended to put the product in an environment of
30-40 ℃ for heating for 1H before use (the heating time cannot exceed 3H)
The construction method can refer to the construction instructions or consult our technicians.

Storage:
Sealed and stored in a low temperature and dry place. It is recommended to store in an environment with a
temperature of 5~25 ℃ and a humidity of ≤ 50% RH.
Storage period: 9 months

Transportation: moisture proof, rain proof, sun proof, high temperature proof, keep away from heat source, handle with care, and do not squeeze or collide.